BB your post does make sense. At the meeting on Friday Murray did mention that the drill results would be brought to Alberta to be released.

I sincerly hope it would be presented in a clear and proffesional presentation. As to not leave any grey areas. I would like to see it in laymans terms as you mentioned as well. We all saw what happened when the last results were put out in an unprepared fashion. Leaving bullboards to do the interpretation. I'm not claiming to be a pro at how the juniors run their companies but are drill results not the most important thing there can be for them?? If it was me I would be presenting them as I stated above in a very prepared and proffesional manner. I believe the sp did not have to take such a hit last time if this had been done and all the factors explained to shareholders.

I was at the meeting as well. In my head I just keep hearing the saying "If it sounds too good to be true" we're certainly going to put that saying to the test.

Just don't get any bad feelings or vibes though. I'll be holding on till the end.

I suspect anyone who thinks this board is too positive would not enjoy one of these meetings and would really dislike Murray.

As it was said at the meeting "the finish line is near" so hang on people.

Nice to see so much excitement! No pun intended, but I'm a junior when it comes to junior's. When a stock like this is halted how much of a delay is it usually until news is released? It's like being a kid at Christmas, we know a gift is there for us, just don't know if its what we're really hoping for. With the timing as far as permit submission and likely approval timeline I would say its gotta be it.

Here's hoping to it being great news. I'm either going to the penthouse or the outhouse.

Pud

how does that saying go?? "when the going gets tough???"

More of a reader than a poster. But sure wife and I sure would be interested in meeting a few of you people. Count us in.